By default only the mainstream gets activated, but to use the substream all you need to do is select it from the drop down box. Do not try to select reolink as the brand of camera from the drop down, all you need to do is put the IP address of your camera in the URL box, put in your login and password information and make sure that the ONVIF port in blue iris is set to 8000, then hit Find/Inspect and all the correct settings will auto populate. and add a new camera with motion detector and direct to disk recording enabled. Next open up Blue Iris and make sure you are on version 5.5.5.0 or greater. Hit save, and you’re all done in the camera’s interface. Take note the ONVIF port is set to 8000, because we need to know that later in blue iris. We want to enable HTTPS, RTSP, and ONVIF. Reolink lets set a custom NTP server, so if you run local NTP you can set that up, and then click on port settings to turn different features on and off. Next in network settings you can toggle different services on and off, if you’re only planning on using blue iris you can turn UID off, but if you want to use your camera with the reolink phone app or desktop app you need to leave UID on. Don’t forget to also change the interframe space on the substream to 1x since that’s what blue iris is going to use for motion detection. Next go to stream and turn on Fixed Frame Rate, set the interframe space to 1x, and adjust your framerate as desired, I prefer 15fps on both the main stream and the substream. Either way, clicking that box will reset your camera to factory settings, so if there are any issues with that pertaining to your specific network, you can try to not reset to default, but I suggest doing it.Īfter the upgrade finishes you’ll log back into your camera with the default username of admin and blank default password, then you should immediately go to settings, system, user management and add a password to the admin account. pak file that you unzipped and click the box that says “reset configuration”, or it might say “update config file”. Click on settings, then system, then maintenance, and click on browse in the firmware update section. Once you’ve got the latest firmware downloaded, unzip the downloaded file and head over to your Reolink camera’s IP address. The release notes that we’re most interested in are “Upgraded ONVIF protocol to version 21.06”, “Added the fixed FPS setting: The FPS won’t be reduced at night”, “Added multiple selection for the iFrame setting”, and if we go back a couple of firmware release notes we can see the most important update for blue iris compatibility “Updated RTSP version”. However, recent updates to blue iris and reolink firmware appear to have fixed all the issues, so this is a quick video to show you how to get your Reolink 8 megapixel cameras working properly with ONVIF network video recorders like Blue Iris.įirst you need to make sure your Reolink cameras are updated to the latest firmware by going to the download center and locating your specific camera model. In my video about Reolink cameras I talked about the fact that Reolink 8 megapixel cameras have historically not worked well with Blue Iris.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |